Home What's New Message Board
BigPumpkins.com
Select Destination Site Search

Message Board

 
Soil Preparation and Analysis

Subject:  Raising PPM with good balance

Soil Preparation and Analysis      Return to Board List

From

Location

Message

Date Posted

Holloway

Bowdon, GA

My spring soil test says balance and Ph are very good for melons, however the PPMs are lower in some areas than I usually have. I would like Ca, Mg, and K higher. Without raising ph higher, gypsum, mag sulfate, and potassium sulfate get me there still in balance. However this would push sulfur levels way up. I think if my calculations are right the end result would be sulfur around 600 ppm. Is that too high? Any other suggestions to raise CA,Mg,K without raising ph?

4/6/2016 8:37:26 PM

Condo*

N.c.

600 ppm S did not seem to bother my pumpkin and bushel gourd plants in sandy loam.

4/7/2016 9:41:14 AM

Christopher24

aurora, IL

Adding gypsum will raise Ca and maybe Mg, but not pH.

4/7/2016 1:55:11 PM

HankH

Partlow,Va

don't worry about the sulfer levels here in the east H2O is naturally acidic and will do the job

4/7/2016 10:44:51 PM

Holloway

Bowdon, GA

I have a clay loam soil so I'm not sure how fast the sulfur will leach. I know some people's sulfur is high but I was concerned at high levels it might effect beneficial fungi. Sulfur is used as a fungicide wasn't sure what happens at high levels. My ph is where I want it so I'm trying to avoid lime. Gypsum, mag sulfate, and potassium sulfate won't raise ph but I would be triple dosing the sulfur. Thanks for the answers.

4/7/2016 11:11:18 PM

Condo*

N.c.

Hey Holloway! I do not know the answer to your question, but from what I been able to find so far 20 ppm S might be close to ideal for mycorrhizal fungi. So just speculating here....600 ppm S is probably way too much. Last year I tried a few of the products from NPK Industries Raw Soluble line of plant nutrients. I was really impressed and I will be using a lot more of their products this year.

4/8/2016 8:21:56 AM

Holloway

Bowdon, GA

Thanks Condo, I think I can get a little higher on ph after seeing some other melon growers did well at those levels so I will try to get as close as I can with lime and finish it off with sulfates.

4/8/2016 9:34:21 AM

cntryboy

East Jordan, MI

600 ppm (or more) of sulfur has never hurt us here. The plants need and use a lot of sulfur.

4/8/2016 5:34:22 PM

Holloway

Bowdon, GA

Thanks Cecil

4/12/2016 10:08:13 PM

Total Posts: 9 Current Server Time: 12/21/2024 9:22:21 AM
 
Soil Preparation and Analysis      Return to Board List
  Note: Sign In is required to reply or post messages.
 
Top of Page

Questions or comments? Send mail to Ken AT bigpumpkins.com.
Copyright © 1999-2024 BigPumpkins.com. All rights reserved.